计算机与现代化 ›› 2010, Vol. 1 ›› Issue (10): 194-197.doi: 10.3969/j.issn.1006-2475.2010.10.054
• 应用与开发 • 上一篇 下一篇
龚琪琳1，李忠志2，黄 鸿3
收稿日期:
修回日期:
出版日期:
发布日期:
GONG Qi-lin1, LI Zhong-zhi2, HUANG Hong3
Received:
Revised:
Online:
Published:
摘要： 本车模控制器的设计基于凌阳单片机(SPCE061A)和PWM电机控制技术。该控制器能接收和判断模拟驾驶舱的无线主控制信号，根据主控制信号对车模进行控制，如前进、后退、加速、减速、拐弯及刹车等。采用16位凌阳单片机(SPCE061A)控制片外定时器(8253)输出控制信号(PWM)，信号具有误差小、控制级数高、稳定性好的性能特点。
关键词: 凌阳单片机, 定时器, PWM
Abstract: This design of mold vehicle controller is based on control technologies of single-chip microcomputer and PWM direct current motor. The controller can receive and judge the main control signals from the imitate driving room and put out signals to control the mold vehicle according to different main control signals, such as headway, retreat, accelerate, decelerate, turn a corner and put on brakes, etc. Adopting 16-bit single-chip machines of Lingyang to control slice outside 8253 to put out signal of PWM, the output signal has characteristics of small error, high control series and good stability.
Key words: single-chip microcomputer of Lingyang, timer, PWM
中图分类号:
TP273
龚琪琳;李忠志;黄鸿. 车模控制器设计[J]. 计算机与现代化, 2010, 1(10): 194-197.
GONG Qi-lin;LI Zhong-zhi;HUANG Hong. Design of Mold Vehicle Controller[J]. Computer and Modernization, 2010, 1(10): 194-197.
0 / / 推荐
导出引用管理器 EndNote|Ris|BibTeX
链接本文: http://www.c-a-m.org.cn/CN/10.3969/j.issn.1006-2475.2010.10.054
http://www.c-a-m.org.cn/CN/Y2010/V1/I10/194
